MINEX-S is a permanent magnet coupling transmitting torque by magnetic forces between an outer and inner rotor. A containment shroud provides a hermetic seal allowing the coupling to be used with pumps circulating dangerous media. Dynamic shaft seal leaks become a thing of the past when a conventional mechanical coupling assembly is replaced with the MINEX-S. Features. Torque transmission without mechanical contact. Hermetic separation of drive and driven sides. Prevents leakage by use of static seal. Maintenance free and environmentally safe. For use in locations where flammable or combustible vapors, liquids, dusts or residues are present and near sensitive magnetic equipment. Torque transmission without contact ! (permanent magnets). Torque transmission up to 315 Nm. Maintenance-free. Perfect seal between the motor side and the receiver side (avoids mechanical fittings). ATEX certified. Stainless steel discs for high temp up to 250 degrees. Zero backlash, high torsional stiffness. Low stress under misaligned conditions. High speed capability. Precisely machined aluminum hubs and spacers.

Torque transmission without contact ! (permanent magnets). Torque transmission up to 315 Nm. Maintenance-free. · Perfect seal between the motor side and the receiver side (avoids mechanical fittings). ATEX certified. Types of applications : Pumps: centrifugal rotor pumps, dosing pumps, propeller pumps. Mixers: chemical, food, pharmaceutical, colourings applications, etc… operate similar to standard centrifugal pumps, except the impeller is driven with a magnetic coupling, eliminating the need for a shaft seal. Extended life brush-less DC models are currently available. Typical applications include film processors; laser and x-ray cooling systems; medical, scientific and laboratory equipment and silver recovery equipment. Non-Sparking, Non-Magnetic, Corrosion-Resistant. Meets OSHA and NFPA Requirements For Use in Hazardous, Flammable or Combustible Environments. Factory Mutual Approved. Beryllium Free Lifetime Warranty. Machined concave jaw pockets. Steel, aluminum or cast iron hubs. Urethane spider inserts. Horse Power range from 1 to 4500hp. Bore sizes up to 7.75 inches.